Ceramic Tile Refinishing for Los Angeles County Bathrooms and Kitchens
Original Tile, Restored the Right Way Since 1955
Most tile we’re called out for across Los Angeles County is structurally sound; it’s the glaze that’s worn through and the grout that’s absorbed years of soap residue and hard water. That distinction matters, because it means a fresh glaze coat and a properly sealed grout line, not a tile tear-out, is usually the whole fix. Porcelain and Fiberglass Maintenance, Inc. has been making that call since 1955.
The Glaze Is the Problem, Not the Tile
Refinishing puts a fresh glaze coat over the entire tile surface, not just the individual tiles but the grout lines between them, sealing everything as one continuous, easy-to-clean surface. The process cleans the tile and grout completely, repairs any cracked or chipped tiles, chemically etches the glazed surface so a coating can bond, then applies the new glaze coat and seals every grout line. The result looks new without a single tile being removed.
Original Tile Worth Keeping, Not Replacing
Los Angeles County’s mid-century homes hold some of the most distinctive original tile work anywhere in the region, patterns and colors that would be expensive, sometimes impossible, to replicate today. Refinishing lets homeowners across the county keep that original tile rather than tearing it out. It’s also common practice before listings and during rental turnover, since a fresh tile surface reads as a fully updated bathroom to a buyer or tenant without any of the mess or delay of a real renovation.
How to Tell If Your Tile Needs a Refresh
A glazed surface that looks dirty no matter how much it’s scrubbed
Grout that’s discolored or stained despite regular cleaning
Cracked or chipped individual tiles
A dull, worn glaze that used to have shine
Grout lines that have started to crumble or gap
If the tile itself is sound and it’s just the glaze and grout showing their age, refinishing is almost always the right call over a full tile tear-out.
The Glaze-and-Seal Process
1
Check the Tile
We check whether the tile itself is structurally sound before quoting anything.
2
Deep Clean the Grout
The tile and grout are deep cleaned to remove soap residue and hard water deposits.
3
Fix Chips First
Cracked or chipped tiles are repaired and sanded flush before coating.
4
Etch the Glaze
The glazed surface is etched so the new coating can bond properly.
5
Glaze Coat
A fresh glaze coat is applied across the entire tile surface for a uniform, glossy finish.
6
Grout Sealing
Every grout line is fully sealed as part of the same visit, protecting against future staining.
7
Final Cure
The glaze cures over the following day, with the grout seal setting alongside it before the room goes back into daily use.
Where We Refinish Tile
We refinish ceramic tile in bathrooms and kitchens throughout Los Angeles County, from tub surrounds and shower walls to floor tile and backsplashes. The same glaze-and-seal process works across all of them, and it’s often paired with tub, shower, or sink refinishing in the same visit when a full bathroom is being updated.
Five Hundred Tile Walls Later
500 sets of tile walls in a single hotel is the kind of volume that only comes from getting the process right, visit after visit.
That scale of work runs in the family. Meet the three generations behind it.
Straight Answers on Tile Refinishing
Bring Your Original Tile Back to Life
Every job starts in North Hollywood and reaches original tile throughout Los Angeles County, since 1955.